Schley Tools - 3-Piece Pneumatic Drift Pin Set, 8mm, 10mm and 12mm Extra Long, 11600 1989-Up allowing this tool to be

allowing this tool to be use on steering gear with either short or long sector shafts

Simplifies tough automotive servicing tasks

After removing the wires and retaining bolts

Weighing approximately 16 pounds

Due to the 18-20° axle housing angle on the Dodge 4500/5500 pickup trucks a special adapter is required to support the 18100 Ball Joint Press to properly install the ball joint

Schley Tools - 3-Piece Pneumatic Drift Pin Set, 8mm, 10mm and 12mm Extra Long, 11600 1989-Up allowing this tool to beThis tool is designed to drive out long bolts and pins (up to 5 long) that over time have been frozen in place by corrosion. Components you might use this tool on would be alternator pivot, suspension arms, control arms, shocks, leaf springs, and many other applications all could have bolts too long to remove with conventional drift, or tapered punch without it becoming stuck creating additional time consuming problems three different sizes allow use