Servo, Hitec HS-422 Standard but you can cut the

but you can cut the default trace and add a solder jumper if you need to switch to 3

2x RFID Card - 125kHz åÊ

be sure to connect to the ‰ÛÏRAW‰۝ pin and not VCC

Gear Type: Nylon

There‰۪s also a reset button

Servo, Hitec HS-422 Standard but you can cut theControl System: +Pulse Width Control 1500usec Neutral Required Pulse: 3 5 Volt Peak to Peak Square Wave Operating Voltage: 4. 8 6. 0 Volts Operating Temperature Range: 20 to +60 Degree C Operating Speed (4. 8V): 0. 21sec 60 at no load Operating Speed (6. 0V): 0. 16sec 60 at no load Stall Torque (4. 8V): 45. 82 oz in. (3. 3kg. cm) Stall Torque (6. 0V): 56. 93 oz in. (4. 1kg. cm) Operating Angle: 45 Deg. one side pulse traveling 400usec Continuous